Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Cap & Crown Cost in Hillsboro?
A chimney cap installation in Hillsboro typically costs $250 to $600, including the cap and the labor to fit it. A crown repair usually runs $300 to $700, while a full crown rebuild lands between $700 and $1,500 depending on the crown’s size and how much masonry the repair touches. If the crown is cracked and the flue underneath is sound, HeatShield resurfacing can run $1,200 to $2,500 and often saves you the cost of a full reline.
Those are typical, estimated ranges for the Hillsboro market in 2026. Your written estimate sets the final price, and our estimates are free. Call (855) 473-8720 to book one. We answer 24/7.
Chimney Cap & Crown Cost Breakdown (2026)
Here’s how the pieces usually price out. Ranges are per job, not per hour, because a straightforward cap swap on a single-flue chimney takes a very different amount of time from a crown rebuild on a wide masonry chimney.
| Line item | Typical estimated range | What’s included |
|---|---|---|
| Standard single-flue cap, supplied and installed | $250 – $450 | Stock-sized cap, sealant, fitment, roof-edge safety setup |
| Custom or multi-flue cap | $400 – $600+ | Made-to-measure cap for an oversized or multi-flue crown |
| Cap for a gas-appliance flue | $200 – $400 | Smaller cap sized for the vent, often a low-profile design |
| Crown repair with sealant or coating | $300 – $700 | Cleaning the crown, filling cracks, applying a crown coating |
| Partial crown rebuild | $500 – $900 | Rebuilding the damaged section with mortar, matching the profile |
| Full crown rebuild | $700 – $1,500 | Removing and reforming the entire crown, proper slope, bond break |
| Crown rebuild plus flue resurfacing | $1,500 – $3,000 | Crown work plus HeatShield resurfacing where the flue is sound but damaged |
| Cap and crown together | $600 – $1,200 | Combined visit, which is cheaper than two separate trips |
What drives the price up? A wide masonry chimney with a big crown takes more material and more time than a narrow one, and there’s a real difference between a crown coated in place and one that has to come off and be rebuilt from the mortar up. Reaching the crown safely also matters: a steep roof pitch or a tight spot between the chimney and a ridge takes longer to set up for than a chimney on a low-slope section. Materials matter too. We source caps and covers through professional chimney supply lines (Gelco, Famco, Copperfield and Olympia Chimney), not the big-box shelf, and the gauge of the metal and the quality of the mesh are what separate a cap that lasts from one that rusts through in a couple of seasons.
On the lower end, a standard cap on an easily reached single-flue chimney with nothing else wrong is the simplest job in the table. On the higher end, you’re looking at a full crown rebuild with proper slope and a bond break, plus the resurfacing work that goes with a flue that has visible damage. We’ll tell you honestly which one you actually need before any work starts.
What Affects Chimney Cap & Crown Pricing in Hillsboro
- Roof pitch and access. Hillsboro’s older homes, especially around the downtown core and along the streets near Hare Field, often have steeper roof pitches than newer construction. A steep pitch means more time spent setting up safe roof-edge access, and that setup is part of the job cost.
- Chimney width and crown size. A wide masonry chimney with an oversized crown takes more mortar, more formwork and more time. A narrow single-flue crown costs less because there’s simply less to rebuild.
- Number of flues. Multi-flue chimneys need a bigger, multi-hole cap or individual caps on each opening, and the crown itself spans a wider footprint. Both add to the total.
- Crack severity. A hairline crack that can be cleaned and coated is cheap. A crown that’s spalling, where chunks are flaking off, or crumbling at the edge, usually needs a rebuild rather than a patch.
- Flue condition beneath the crown. If the crown has been failing for a while, water has likely gotten into the flue. That’s when a flue inspection matters, because the crown repair alone won’t fix a damaged liner underneath. HeatShield resurfacing can often save the cost of a full reline when the tile is damaged but structurally sound.
- Material choice. A galvanized cap costs less than a stainless one, but stainless holds up better to the wet winters we get in the Tualatin Valley. That’s a long-term value question, not just a price question.
Why Crown and Cap Work Matters More Here Than in Drier Climates
Hillsboro sits in the Tualatin Valley, and the valley gets a long, wet stretch from late fall into spring. That’s the climate that does the most damage to a chimney crown. A masonry crown is the concrete or mortar slab on top of the chimney, and its whole job is to shed water away from the structure. Once a crack opens, water gets in, freezes on a cold night, expands, and widens the crack. Repeat that over a few winters and a small repair turns into a crown rebuild.
A cap does the complementary job. It keeps rain from dropping straight down the flue, and it keeps birds, squirrels and debris out. Around Hillsboro’s tree-lined neighborhoods, that last part matters more than people expect. A cap that’s loose or missing means the flue becomes a home for whatever’s looking for shelter.
We’re a chimney specialist, not a generalist. Every technician’s skill set is built around this one system, so a cap and crown visit isn’t a side job we squeeze in between other trades. It’s the work we do. Our technicians have up to experience.
If you own a home with an unknown chimney history, which is common with Hillsboro’s older housing stock and recently purchased homes, a standalone inspection is the right starting point. A chimney inspection isn’t an upsell. It’s how we determine what your flue actually needs, and you can book it on its own before committing to any repair.
How to Save on Chimney Cap & Crown
These are the practical levers that move the number down, in order of how much they tend to help.
- Fix the crack before it becomes a rebuild. A crown coating or sealant job in the $300 to $700 range today can head off a $700 to $1,500 rebuild later. Water damage compounds; small repairs don’t stay small once freeze-thaw gets involved.
- Combine the cap and crown in one visit. Doing both at once usually costs less than the two line items added separately, because the access setup and roof-edge safety time is only paid for once.
- Choose stainless over galvanized where it counts. A galvanized cap is cheaper up front, but in a wet valley climate a stainless cap lasts longer. Ask us for both prices so you can compare on total cost, not just the first invoice.
- Get the inspection first if the chimney’s history is unknown. A standalone inspection tells you whether you’re looking at a coating job, a rebuild, or a flue problem underneath. Guessing can mean paying for a crown repair that doesn’t solve the actual issue.
- Ask about HeatShield before agreeing to a reline. When the flue tile is damaged but structurally sound, resurfacing is often the lower-cost path. We’re certified to apply HeatShield, and we’ll tell you plainly which option your flue actually needs.
Estimates are free, and the price is set per job by the written estimate, so you’ll know the number before any work begins. Call (855) 473-8720 to schedule. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Can a Damaged Crown Wait Until Next Year?
Usually no. A crown with an open crack lets water into the chimney structure every time it rains, and Hillsboro gets plenty of rain. Freeze-thaw cycles in winter widen the damage. Waiting a season often turns a coating job into a rebuild, and sometimes into flue damage that needs resurfacing. If you can see cracking, spalling or a crumbling edge on the crown, get it looked at before the wet season sets in rather than after.
We answer 24/7. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm.
Do You Need a Cap and Crown on a Gas Fireplace Flue?
Yes, and it’s often overlooked. A gas appliance flue still terminates at the top of the chimney and still needs a cap to keep rain and animals out, though the cap is smaller and sometimes lower-profile than one for a wood-burning flue. The crown on a gas-only chimney still needs to be intact, because the crown protects the masonry structure regardless of what’s burning below. Cap costs for a gas flue typically fall in the $200 to $400 range.
If you’re not sure what’s on top of your chimney, that’s exactly what an inspection resolves. We handle sweep, inspect and repair under one company, so there’s no handoff to a third party for a different part of the job.
If you’re looking for a full-service chimney professional in Hillsboro, we cover the whole cycle from inspection through cleaning through repair. When you’re ready to book, see our chimney sweep Hillsboro page or call us directly.
FAQs – Chimney Cap & Crown Cost
How much does a chimney cap cost in Hillsboro?
A chimney cap in Hillsboro typically costs $250 to $600 supplied and installed, with custom and multi-flue caps on the higher end. Gas-appliance flue caps usually run $200 to $400. Call (855) 473-8720 for an exact quote. Estimates are free.
How much does a chimney crown rebuild cost?
A full crown rebuild typically runs $700 to $1,500, while a partial rebuild or a coating repair falls between $300 and $900. The final number depends on crown size and how much masonry the repair touches. Call (855) 473-8720 to get a written estimate for your chimney.
Is it cheaper to repair or replace a chimney crown?
Repair is cheaper when the crown is cracked but sound, at roughly $300 to $700 versus $700 to $1,500 for a rebuild. Replacing the crown is the better value once it’s spalling or crumbling, because patches on a failing crown don’t last. Call (855) 473-8720 and we’ll tell you which one yours needs.
Can you install a cap and fix the crown in one visit?
Yes, and it usually costs less than booking them separately, typically $600 to $1,200 combined. One visit means one access setup and one roof-edge safety arrangement. Call (855) 473-8720 to book both together.
Does HeatShield resurfacing cost less than a full reline?
It often does. HeatShield resurfacing typically runs $1,200 to $2,500, and it’s an option when the flue tile is damaged but structurally sound, so it can save you the cost of a full reline. We’re certified to apply it, and we’ll tell you honestly which one your flue actually needs. Call (855) 473-8720 for a free estimate.
How much does it cost to have a specialist check my chimney first?
The inspection is a standalone service, and the estimate that follows is free. You can book just the inspection before committing to any cap or crown work. Call (855) 473-8720. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
We carry the professional materials, DuraFlex liner systems, HeatShield resurfacing, and caps and components from Gelco, Famco, Copperfield and Olympia Chimney, because a cap that lasts is a different product from what’s on the shelf at the hardware store. Sweep, inspect, repair, handled by the same specialist, start to finish. If your crown is cracked or your cap is missing, call (855) 473-8720 for a free estimate and we’ll give you the real number for your roof, not a guess.
Pricing reflects the Hillsboro market as of 2026. Chimney Sweep Hillsboro offers free estimates – call (855) 473-8720.
Written by the team at Chimney Sweep Hillsboro.
What Our Customers Say
"Thorough sweep and a clear report. He was running late from the job before and arrived near the end of the window, though he did call to warn me."
- Craig Gallagher"Level two inspection before we bought the house. The report was detailed enough to use as a negotiating point and he explained every photo in it."
- Michelle Tran"Cap keeps the birds out now, which after two springs of scratching noises is worth every penny."
- Renee Hayes